Menu

Coil Bonding

DELO KATIOBOND Key Features

Light-activated versions can be used in opaque applicationsVery fast curing to minimise process costsEpoxy base ensures dry surface after cureExcellent chemical resistanceOne-part, ideal for manual or automated processing

One of the component parts of automotive temperature control systems consists of a lacquered copper coil bonded to a PCB. Because the lacquer is temperature sensitive, heat cannot be used in the curing process. Also, as the coil creates a shadow zone, UV light cannot be used in order to avoid uncured adhesive.

Pre-activating an adhesive with light before joining the components is the ideal solution. The adhesive receives enough energy in the 5-second pre-activation process to fully cure in time, and there is enough adhesive visible after the joining process to illuminate for a further 10 seconds and therefore achieve high initial handling strength.

The final assembled parts are then tested to exacting automotive requirements: 1,000 hours storage at +125°C; 100 temperature cycles between -65°C / 20 minutes and +150°C / 20 minutes; 100 thermal shock cycles between -65°C / 5 minutes and +150°C / 5 minutes; & humidity testing for 1,000 hours at +85°C / 85% RH.

12345PreviousNext

Light-Activated Adhesives Technical Downloads

File

DELO KATIOBOND Selection Chart

Download

File

DELO PHOTOBOND Selection Chart

Download

File

DELO Bonding in Electronics Brochure

Download

Visit the Inseto (UK) Ltd website for more information on Coil Bonding

ENQUIRY FORM

More Products

  • XB8 Wafer Bonder

  • Wire Pull & Bond Shear Tester: Dage 4000 Optima

  • XBS200 Wafer Bonder

  • Wire Pull Test: Microelectronic Devices